Weil Double Seal Submersible Pumps can be used to pump wastewater, unscreened solids, water containing silt and a wide range of pollutants. Suitable applications include wastewater pits, below ground vaults, truck loading docks, parking lots, storm water pumping from underpass drainage and areas flooded from overflowing rivers, streams, etc.

Pump Features

Case

Heavy-duty, close grain, high-density cast iron. Tripod support legs on floor models.

Impeller

Statically and dynamically balanced. Cast iron impellers are standard on all models. Bronze is available as an option on most models.

Strainer

Cast iron or stainless steel.

Hardware

Stainless steel except for discharge flange bolts.

Tandem Seals (Standard)

Two seals. The upper seal operates inside the seal chamber. The upper seal faces are carbon against ceramic. The lower seal faces are silicon carbide against silicon carbide. Note that the 9706 motor is constructed with carbon/ceramic on both the upper and lower seals and is available in tandem style only.

Double Opposed Seals (Optional)

Two seals. Both seals are in a constant oil bath. The upper seal is carbon against ceramic. The lower seal face is silicon carbide against silicon carbide. Not for pump heads exceeding 80 feet TDH. Not available on 9706 motors.

Motor Features

Motor Type

NEMA 6, submersible air-filled, hermetically sealed, Class F insulation.

Motor Voltage

Single-phase voltages are 115 or 208-230 with auto-reset thermal and overload protection. Three-phase voltages are 208-230 or 460 volt. Single and three-phase 50 Hz models are also available.

Motor Shell

Heavy cast iron with special integral cooling fins to permit trouble free operation while running in a non submerged condition.

End Bell

Cast iron, air-filled, hermetically sealed, NEMA-6 design. Hermetic glass seal that separates the motor cavity from the power cord entrance. A power cord leak due to a cut and/or other damage will not permit water to enter the motor.

Elastomers

Buna-N (Nitrile) rings for positive sealing. Viton (fluorelastomer) is available.

Power Cable

All models have 25 feet of neoprene jacketed cable as standard.

Bearings

Permanently lubricated single-row, double sealed. Oversized to handle radial and axial loads.

Shaft

Series 300 stainless steel on 9709 and 9727 motor models. 9706 motor model has 416 stainless steel shaft.

Options

  • Bronze impeller
  • Moisture sensor and temperature limiter
  • 50 Hz motors
  • UL Listed, Class 1, Group C & D explosion proof motor
  • High temp seal and o-rings
  • Black epoxy paint
  • Extra power cable lengths

Some options are not available on all models.

Model Index Page

Download Model Index (PDF)